Hello everyone, this is my first question in the forum, and the truth is I'm lost in the search for an electronic failure of a Ford International Motor 3.0 with injection Siemens. The question is van that the vehicle would not start the scanner accused the CKP sensor had problems and metire and down the UNPLUG truck tab. Please watch out that with touches of it were isolated by a thin film of dried oil isolating the connection, the clean but after cleaning still did not start the vehicle, so escanne again for DTC mistakes and not econtre nothing but a desynchronization and an error signal in the camshaft sensor but the sensor wiring works and is well... I looking happened when not start but I realized, when turned slow the ignition key, starts the truck... no longer do change all capacitors sources of the ecu and review all the tiles from the drum and board and ECU achievement encotntrar not the cause of this failure...
↧