I have this with ABS VSC faults cannot communicate with any scanner I found water ingress and terminals rotten at module with pump . I replaced both front and rear pads as linings near to metal and fluid was previously down very low because of this! The fluid is up OK but brake warning light still on. I am guessing the reservoir sensor could be faulty and wondered if anyone knows what ohms I should expect if I test the sensor in this? Customer is not happy with me as they brought the car in with 3 lights on dash ABS VSR and red brake warning light!
They don't seem bothered car had no brake linings only concerned with lights on dash!
The pads have no wear sensors I cannot see the park brake switch I am guessing problem more likely the fluid sensor and it seems the easiest item to initially test and get rid of this whinging customer who has had enough of me giving him nothing but bad news![headbang]( "headbang")
They don't seem bothered car had no brake linings only concerned with lights on dash!
The pads have no wear sensors I cannot see the park brake switch I am guessing problem more likely the fluid sensor and it seems the easiest item to initially test and get rid of this whinging customer who has had enough of me giving him nothing but bad news
