Have an A Class with CVT transmission problems.
It flags the next errors:
0722: RPM signal of component Y3/9B3 is not available
0739: Secondary RPM signal of component Y3/9B5 is not available
After some searching found that both sensors are mounted on 2 poles together with the CVT electronics. Both sensors share a common +/- for power supply.
My guess is that one of these 2 connections is not fixed 100% between the electronics PCB abd the rails to the sensors.
I will open the oil proof compartment to check and fix this, but...
What glue/material to use to close the compartment again?
It should withstand temperatures of at least 80 degrees and resistant to gearbox oil.
Any one did do a repair like this before? Please share your knowledge...
All help is welcome.
It flags the next errors:
0722: RPM signal of component Y3/9B3 is not available
0739: Secondary RPM signal of component Y3/9B5 is not available
After some searching found that both sensors are mounted on 2 poles together with the CVT electronics. Both sensors share a common +/- for power supply.
My guess is that one of these 2 connections is not fixed 100% between the electronics PCB abd the rails to the sensors.
I will open the oil proof compartment to check and fix this, but...
What glue/material to use to close the compartment again?
It should withstand temperatures of at least 80 degrees and resistant to gearbox oil.
Any one did do a repair like this before? Please share your knowledge...
All help is welcome.