Does any method still exist to allow KI906 to be married to another car?
I am not bothered about mileage, just wish to allow instruments from one W906 to work in another W906 (obviously after running initial startup and SCN coding).
I tried this approx. 2 months ago on an older W906 that did not need SCN (approx. year 2010) and it would not work, then I tried again recently on a newer W906 (2015) and it would not work.
Best that would happen is when I change switch to say instruments are not configured, mileage just shows ------, initial startup would start and even SCN coding would happen fine if required, but could not successfully complete initial startup.
I heard that maybe need to reset mileage to 000000 first. Is this true?
And if so is there any way using Xentry/Das/Vediamo or does this need dump from instruments to be modified?
I am not bothered about mileage, just wish to allow instruments from one W906 to work in another W906 (obviously after running initial startup and SCN coding).
I tried this approx. 2 months ago on an older W906 that did not need SCN (approx. year 2010) and it would not work, then I tried again recently on a newer W906 (2015) and it would not work.
Best that would happen is when I change switch to say instruments are not configured, mileage just shows ------, initial startup would start and even SCN coding would happen fine if required, but could not successfully complete initial startup.
I heard that maybe need to reset mileage to 000000 first. Is this true?
And if so is there any way using Xentry/Das/Vediamo or does this need dump from instruments to be modified?