Hi fellow AP's. ![bow]( "bow")
I have an issue here with a Saxo Cup 1.6 petrol 120hp with IAW 48P2.
ECU ref: 9642774380 S/W ref: 9648620780, which according to owner it was already immo off, but since he decided to have car repainted, the garage where he took it to, after finishing the painting they saw the cable that connects to the immo box disconnected and they decided to connect it, so when they decided to turn on the car it did not start.
I have told the owner to try the trick to remove the ECU and immo box and use them on a donnor car with the key in the transponder, but it did not work because the donnor car was immo off already or probably the key does not have chip in it because the immo light according to owner does not show up.
He tried the donnors ECU on his car but without the immo box connected and it started, so it seems the problem is with ECU being locked or damaged when they connected the immo box back on.
So I told them to send me ECU and I have read the AM29F400BB dump which is attached, and also reprogrammed the flash with UID 3.2 also attached. It's been tested and car won't start. It will crank but won't start.
Can somebody help me to verify if the dump has relocked itself and if the file done by UID 3.2 has done the job correctly as I see some differences on hex files but not sure if properly off?
Kindly advise.![bow]( "bow")
I have an issue here with a Saxo Cup 1.6 petrol 120hp with IAW 48P2.
ECU ref: 9642774380 S/W ref: 9648620780, which according to owner it was already immo off, but since he decided to have car repainted, the garage where he took it to, after finishing the painting they saw the cable that connects to the immo box disconnected and they decided to connect it, so when they decided to turn on the car it did not start.
I have told the owner to try the trick to remove the ECU and immo box and use them on a donnor car with the key in the transponder, but it did not work because the donnor car was immo off already or probably the key does not have chip in it because the immo light according to owner does not show up.
He tried the donnors ECU on his car but without the immo box connected and it started, so it seems the problem is with ECU being locked or damaged when they connected the immo box back on.
So I told them to send me ECU and I have read the AM29F400BB dump which is attached, and also reprogrammed the flash with UID 3.2 also attached. It's been tested and car won't start. It will crank but won't start.
Can somebody help me to verify if the dump has relocked itself and if the file done by UID 3.2 has done the job correctly as I see some differences on hex files but not sure if properly off?
Kindly advise.
| Saxo Cup 1.6 120cv Henrique Benevides.rar | ||
| File Type: |
 |
 |
| Downloaded: | 2 times | |
| Size: | 246.09 KB | |