Hello Guys.
I have Hyundai Coupe 2.0 16V Gasoline engine from 2002 year.
The problem is that after start engine there is Active DTC stored form camshaft sensor P0340.
Timing belt and chain is correct, checked few times.
According to GDS data instruction there are 3 pin wires. Ground, Battery and Signal.
When GDS advise me to check disconnected plug there should be +12, Ground and 0V on pin 2 and i have +5V on pin 2 in disconnected plug.
Pin 2 goes straight to Engine ECU pin 72.
It seems to be something wrong with wires.
Anybody had similar problem?
I have Hyundai Coupe 2.0 16V Gasoline engine from 2002 year.
The problem is that after start engine there is Active DTC stored form camshaft sensor P0340.
Timing belt and chain is correct, checked few times.
According to GDS data instruction there are 3 pin wires. Ground, Battery and Signal.
When GDS advise me to check disconnected plug there should be +12, Ground and 0V on pin 2 and i have +5V on pin 2 in disconnected plug.
Pin 2 goes straight to Engine ECU pin 72.
It seems to be something wrong with wires.
Anybody had similar problem?