Good morning everyone
The immobilized module in the ignition cylinder was replaced because it can't recognize keys anymore. However it can be reached by key programmer xtool X100PRO. The replacement (a used from eBay) was installed. In the key programmer I should use the command "IMMO ECU replacement" but it fails always. The green key still flashing in the cluster and no start.
Can I swap a chip between the two IMMOs ? As I said the old one is reachable by scan tool but no RF transmission exists?
Sorry for the long story.
Thanks.
![[Image: c2467c9e1ca7b8d64d18014ee602211d.jpg]]()
The immobilized module in the ignition cylinder was replaced because it can't recognize keys anymore. However it can be reached by key programmer xtool X100PRO. The replacement (a used from eBay) was installed. In the key programmer I should use the command "IMMO ECU replacement" but it fails always. The green key still flashing in the cluster and no start.
Can I swap a chip between the two IMMOs ? As I said the old one is reachable by scan tool but no RF transmission exists?
Sorry for the long story.
Thanks.
![[Image: c2467c9e1ca7b8d64d18014ee602211d.jpg]](http://uploads.tapatalk-cdn.com/20160224/c2467c9e1ca7b8d64d18014ee602211d.jpg)
![[Image: 3d185641f2e0d26b7d8ea2a2843075e0.jpg]](http://uploads.tapatalk-cdn.com/20160224/3d185641f2e0d26b7d8ea2a2843075e0.jpg)